Throttle/Pedal Position Sensor/Switch A Circuit Malfunction
Was bedeutet das?
Code P0120 indicates a malfunction in the Throttle Position Sensor (TPS) 'A' circuit. The PCM monitors the TPS to determine throttle blade angle.
Haftungsausschluss: Dieser Diagnosecode ist Teil des OBD2-Standards und gilt für Volkswagen Jetta Modelle von 1996 bis 2026. Bitte beachten Sie jedoch, dass dies von der genauen Motorkonfiguration abhängt.
Häufige Ursachen
Defekter Drosselklappenstellungssensor (TPS)
Beschädigter oder gebrochener Kabelbaum
Korrodierter oder loser Steckverbinder
Verschmutzte oder defekte Drosselklappe
Zu beachtende Symptome
- Motorkontrollleuchte leuchtet
- Schlechte Beschleunigung oder träge Reaktion
- Motorschwankungen oder schwankende Drehzahl
- Motor geht unerwartet aus
- Unregelmäßige oder schwankende Leerlaufdrehzahl
- Fahrzeug geht in den Notlaufmodus
Wie man diagnostiziert
Häufige Lösungen
Replace the Throttle Position Sensor (TPS): This is the most common fix if the sensor itself is found to be faulty after voltage signal verification. Ensure the replacement part is of high quality, preferably OEM or a reputable aftermarket brand, as cheap sensors can quickly fail or provide inaccurate readings.
Repair or Replace Damaged Wiring/Connectors: If the diagnostic steps reveal damaged, corroded, or shorted wiring, or compromised connector terminals, these must be repaired or replaced. Use appropriate automotive-grade wiring and connectors, ensuring proper soldering and heat-shrink insulation for durable, long-lasting repairs.
Clean Throttle Body: If the throttle plate is sticking due to carbon buildup, it can put undue stress on the TPS or cause the PCM to interpret the sensor's output as erratic, especially if the sensor is integrated into the throttle body assembly. A thorough cleaning can restore smooth operation and prevent future issues.
PCM Software Update or Replacement: In rare cases, if all other components and wiring test perfectly, the issue might lie within the Powertrain Control Module itself. A PCM software update (reflash) might resolve a known calibration issue, or in extreme cases, the PCM may need to be replaced if its internal TPS driver circuit has failed. This should only be considered after exhausting all other diagnostic avenues.